Functional Description - Makita BO6030 Instruction Manual

4. This tool has not been waterproofed, so do not
use water on the workpiece surface.
Ventilate your work area adequately when you
5.
perform sanding operations.
6. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
7. Use of this tool to sand some products, paints
and wood could expose user to dust contain-
ing hazardous substances. Use appropriate
respiratory protection.
Be sure that there are no cracks or breakage
8.
on the pad before use. Cracks or breakage
may cause a personal injury.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► Fig.1: 1. Lock button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial
► Fig.2: 1. Speed adjusting dial
The rotating speed can be changed by turning the
speed adjusting dial to a given number setting from 1
to 5.
Higher speed is obtained when the dial is turned in the
direction of number 5. And lower speed is obtained
when it is turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the approximate rotating
speed.
10,000
4,000
1
A range: For polishing
B range: For finish sanding
C range: For regular sanding
NOTE:
• The above figure shows standard applications.
They may differ under certain conditions.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Front grip
► Fig.3: 1. Notches 2. Front grip 3. Hole in front grip
4. Screwdriver
Install the front grip on the tool so that its protrusions fit into the
matching notches in the front of the tool. Secure the front grip using
a screwdriver to tighten the screw through the hole in the front grip.
Installing or removing abrasive disc
► Fig.4: 1. Abrasive disc
CAUTION:
• Always use hook-and-loop system abrasive discs.
Never use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or for-
eign matter from the pad. Then attach the abrasive
disc to the pad, using the hook-and-loop system of the
abrasive disc and the pad. Be careful to align the holes
in the abrasive disc with those in the pad.
To remove the disc from the pad, just pull up from its edge.
Changing pad
► Fig.5: 1. Hex wrench 2. Screw 3. Pad
Makita offers an extensive range of optional pads. Remove the screw
counterclockwise from the center of the base with a hex wrench.
After changing the pad, tighten the screw clockwise securely.
Installing dust bag
► Fig.6: 1. Dust nozzle 2. Dust bag
Install the dust bag on the tool so that the arrow with
"UP" indicated on the dust nozzle points upward.
6 ENGLISH
B
A
2 3 4
Dial setting
C
5