Advertisement
Versa Lift
2a. LIFT HEAD ASSEMBLY - Using the Rope Handles
provided, move the Lift Head into the attic for assembly.
Warning! Heavy!! This job requires two able persons.
(After the lift head is in the attic, untie the rope handles
and save them.) Locate the other parts shown below and
move them up to the attic for assembly to the Lift Head.
2b. INSTALL THE HOUSING LEGS
Assemble the four lift housing legs into the lift housing as
shown.
The locknuts will not work loose, so don't over-
tighten or you will collapse the square tubing. Note: The
DO NOT RUN the Lift
CAUTION
!
motor until this manual tells you to!
THE LIFT WILL MALFUNCTION IF YOU DO!
2c. INSTALL THE
MOUNTING RAILS
Fig. 22
Installation - Assembly
!
1/4-20 x1-1/2"
TRUSS SCREW (8)
MOUNTING
RAILS (2)
1/4-20 TALL
LOCKNUT (8)
LIFT HOUSING LEGS (4)
!
Note: The legs fit
to the INSIDE of
the lift housing!
legs must fit to the INSIDE of the lift housing (see inset).
2c. INSTALL THE MOUNTING RAILS
Assemble the mounting rails onto the lift housing legs,
as shown, but do not tighten them yet. Leave them slight-
ly loose for leveling adjustment Step 4.
2d. INSTALL NYLON GUIDE SPACERS
Install two nylon spacers with a 2½" screw and locknut to
the mounting rails in four places (by each leg) as shown
below. Tighten them snug, but do not over-tighten.
½ x 1" NYLON
SPACER (8)
(2 x 4 Places)
1/4-20 x 2-1/2"
2d. INSTALL NYLON
PHILLIPS
PAN
GUIDE SPACERS
HEAD (4)
2b. INSTALL THE
HOUSING LEGS
(All Models)
1/4-20 TALL LOCKNUT (4)
Hardware Needed:
1/4-20 x 1-1/2"
Truss Screws (16)
1/4-20 x 2-1/2" Phil.
Pan-head Screws (4)
1/4-20 Tall
Locknuts (20)
½ x 1" Nylon
Spacers (8)
LIFT HEAD ASSY
LIFT HOUSING LEGS (4)
1/4-20 TALL
LOCKNUT (8)
¼-20 x 1-1/2"
TRUSS SCREW (8)
11
LIFT
HOUSING
Advertisement
