Table of Contents
Advertisement
Installation and Operation Manual
4.4. Electrical Installation
When the supply voltage or the voltage at the relay terminal is below 42 volts, use the standard cable entrance gaskets
to connect the transmitter, the receiver, the output relay and power.
Connect all wiring with more than 42 V through a Greenfield Fitting.
Disconnect power before opening the control unit to prevent electrical shock.
Figure 6: Final installation with Greenfield Fittings (e.g. from Thomas & Betts or other UL / CSA approved manufacturer)
Figure 7: Wiring diagram
© CEDES
Do not remove inside cover or fuse cap.
www.cedes.com
cegard/Max-NT
7
Advertisement
Table of Contents
