Cedes cegard/Max-NT Installation And Operation Manual page 2

cegard/Max-NT Installation and Operation Manual
IMPORTANT NOTES
FOLLOW THE INSTRUCTIONS GIVEN IN THIS MANUAL CAREFULLY. FAILURE TO DO SO MAY
CAUSE CUSTOMER COMPLAINTS OR SERIOUS CALL BACKS. KEEP INSTRUCTION MANUAL ON
SITE.
IT IS THE RESPONSIBILITY OF THE SPECIFIER, PURCHASER AND INSTALLER TO ENSURE THAT
ON COMPLETION, THE INSTALLATION COMPLIES WITH ALL RELEVANT FEDERAL, STATE AND
LOCAL CODES AND REGULATIONS THAT APPLY TO YOUR APPLICATION.
FOR ELEVATOR APPLICATIONS, PARTICULAR ATTENTION SHOULD BE GIVEN TO CLAUSE 2.13.5
REOPENING DEVICES FOR POWER-OPERATED CAR DOORS OR GATES OUTLINED IN ANSI-ASME
A17.1-2016 / CSA B44-16 SAFETY CODE FOR ELEVATORS AND ESCALATORS OR AN EARLIER
VERSION OF THIS STANDARD REQUIRED BY THE AUTHORITY HAVING JURISDICTION (AHJ).
THIS PRODUCT CANNOT FULFILL ANSI-ASME A17.1-2019 / CSA B44-19 SAFETY CODE FOR
ELEVATORS AND ESCALATORS OR LATER VERSIONS DUE TO NEW REQUIREMENTS FOR SELF-
MONITORING AND INTEGRATION OF APPROACHING OBJECT DETECTION. CONTACT YOUR
LOCAL CEDES REPRESENTATIVE IF YOU NEED ASSISTANCE WITH PRODUCT SELECTION TO
FULFILL THE REQUIREMENTS IN THIS VERSION OF THE CODE.
THESE LIGHT CURTAIN SYSTEMS MUST BE INSTALLED ONLY BY AUTHORIZED AND FULLY
TRAINED PERSONNEL. FOLLOW ALL NECESSARY SAFETY PRECAUTIONS DURING THE
INSTALLATION PROCESS, INCLUDING TAKING THE ELEVATOR AND DOOR OUT OF SERVICE
DURING INSTALLATION.
PLEASE TAKE NOTE THAT OBJECTS THINNER THAN THE BEAM SPACING MAY NOT BE
DETECTED.
DO NOT USE THIS PRODUCT FOR THE PROTECTION OF DANGEROUS MACHINERY OR IN
EXPLOSIVE ATMOSPHERES OR RADIOACTIVE ENVIRONMENTS. USE ONLY SPECIFIC AND
APPROVED TYPES OF SAFETY DEVICES FOR SUCH APPLICATIONS. OTHERWISE SERIOUS
INJURY OR DEATH MAY OCCUR.
WHEN SUPPLY VOLTAGES GREATER THAN 42 VOLTS ARE USED, THE INTERFACE WIRING TO
THE POWER SUPPLY AND TO THE DOOR DRIVE MUST BE MADE THROUGH A GREENFIELD
FITTING
.
© CEDES
2 www.cedes.com