Advertisement
Getting to know your 24*7
Preparing the machine for use - Loading foil.
Ensure the 24*7 machine is placed on a flat dry surface away from other large
electrical items which may interfere with the foil recognition system.
Open the top lid of the machine by lifting the
release catch (2) and pulling the lid up. Ensure the
safety catch is engaged holding the lid in the fully
open position as shown in fig 2.
Insert the foil into the locators inside the body of
the machine. The core locators will only accept
the corresponding sized core which hold the foil
- make sure the foil is correctly inserted with the
large core side in the large locator and the small
in the small locator. The foil will feed forward from
the underside of the roll as shown in fig 1.
Pull foil forward as shown in fig 1 making sure foil
is pulled taught and crease free. Pull forward to
allow approx 5cm of foil to overhang the lip of the
machine making sure the foil sensor is covered as
shown in fig 1.
When foil is correctly loaded close the lid of the
machine by releasing the lid stay catch as shown
in fig 2 (green arrows) and then lowering the lid
as in fig 2 (grey arrows). Take care of the sharp
cutting blade when lowering the lid which must be
fully closed in order for the machine to operate
Make sure the machine is plugged into the power
supply and that the on/off switch is in the on posi-
tion (the lights will come on when the machine is
switched on).
You are now ready to select the foil
options you require!
#freedomtocreate
Fig 1.
Fig 2.
Lid Stay Catch
Page 4
Advertisement
