Preparation And Installation; Package Content; Building The Connector Cables - Tattile ANPR MOBILE Series Original Installation Instructions

4 Preparation and Installation

4.1 Package Content

The following products are included in the package:

ANPR MOBILE Device.

Mating parts kit, cod: T17493
For more information on the purchased device model refer to the Technical Specifications.

4.2 Building the Connector Cables

Good equipment operation is guaranteed only by respecting the instructions contained in this manual.
Tattile declines all responsibility for anomalous equipment behavior, if the installation does not follow
these instructions:
‐ Always observe the polarities of the power supplies and the power requirements specified in manual.
‐ Mount the device on a mechanically stable structure, well connected to electrical ground.
‐ Remove the power supply voltage from the device before unplugging the power connector.
‐ Turn off all electrical power before making or breaking any electrical connections. Making or breaking
connections when power is on can result in damage to the device.
‐ Electromagnetic Interferences (EMI) and Electrostatic Discharges (ESD) can cause problems whit your
device.
‐ Do not share the main power supply (V MAIN) with other equipment. Use a dedicated power supply.
‐ Do not place the power supply and signal cables parallel to cables carrying high‐current switching
voltages.
‐ The power supply cable must be shielded.
RMM_00029_09 21 / 42
4 Preparation and Installation
ANPR Mobile