Advertisement
10. Turn on control. Make sure all the motors are running clockwise (spindle motor,
hydraulic motor, cross-feed motor, vertical rapid motor, and coolant pump motor).
1) Release emergency button, turn on green start button. Turn chuck control on.
2) Press spindle, hydraulic and magnetic separator and paper filter system buttons
to check rotation.
3) Check cross-feed motor by pressing in and out push button while function
switch is in manual mode.
4) Check rapid vertical motor by pressing up and down push buttons while
function switch is in rapid mode.
Cross-feed
function switch
(in manual
mode)
Chuck
control
switch
Start button
Emergency
button
If opposite direction, please turn off main power by pushing emergency button.
Switch any two power lines that go into the machine.
Position setting
push button
Variable resistor
swich
Spindle
motor on off
push button
In and out push
buttons
Hydraulic
motor on off
push button
Down feed Start
and off button
Warning! Take out
wheel when testing
spindle rotation.
3 position
function
switch
Up-down push
buttons
Coolant on/off
push button
Advertisement
