EINHELL AGILLO Original Operating Instructions page 19

Trimming/mowing
Swing the trimmer from side to side in a scything
motion. Always keep the line spool parallel to the
ground. Check the site and decide which cutting
height you require. Guide and hold the line spool
at the required height to obtain an even cut (Fig.
18).
Low trimming
Hold the trimmer right in front of you at a slight
angle so that the underside of the line spool is
above the ground and the line strikes the correct
target. Always cut away from yourself. Never draw
the trimmer towards yourself.
Cutting along fences/foundations
Approach wire mesh fences, lath fences, natural
stone walls and foundations slowly so that you
can cut close to them without striking the obstacle
with the line. If, for example, the line strikes
stones, stone walls or foundations, it will wear or
fray. If the line strikes wire fencing, it will break.
Trimming around trees
When trimming around tree trunks, approach
slowly so that the line does not strike the bark.
Walk around the tree, cutting from left to right.
Approach grass or weeds with the tip of the line
and tilt the line spool forwards slightly.
Warning: Take extreme care during mowing work.
When doing such work keep a distance of 100
ft. (30 m) between yourself and other people or
animals.
Mowing
When mowing down to the ground you will cut all
the vegetation. To do this, set the line spool at an
angle of 30° to the right. Place the handle in the
required position. Remember the increased risk of
injury to the user, watchers and animals, and the
danger of damaging property due to objects (for
example stones) being thrown up (Fig. 19).
Warning: Do not use the equipment to remove
objects from footpaths, etc.
The equipment is a powerful tool and can throw
small stones and other objects a distance of 50 ft.
(15 m) or more, causing injuries and damage to
cars, houses and windows.
Sawing
The equipment is not suitable for sawing.
Anl_Agillo_SPK7_USA.indb 19 Anl_Agillo_SPK7_USA.indb 19
EN
Jamming
If the cutting blade jams as a result of attempting
to cut vegetation that is too dense, switch off the
engine immediately. Remove the grass and scrub
from the equipment before you restart it.
Preventing recoil
When you work with the blade, there is a risk of
recoil if it strikes solid objects such as tree trunks,
branches, tree stumps, stones or the like. This will
throw the equipment backwards in the direction
opposite to the rotation of the tool. This can cause
you to lose control of the equipment. Do not use
the blade near fences, metal posts, boundary
stones or foundations. For cutting dense stalks,
position the blade as shown in Fig. 20 to prevent
recoil.
6.3 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.4 Battery capacity indicator (Fig. 14)
Press the battery capacity indicator switch (33).
The battery capacity indicator (32) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
All LEDs fl ashing:
The battery pack has been deep-discharged and
is defective. Do not re-use or charge a defective
battery pack.
- 19 -
05.08.2019 10:37:31 05.08.2019 10:37:31