Advertisement
ANT224D10 IG.fm Page 2 Monday, July 20, 2009 9:43 AM
Antenna Specifications
Frequency range
2.4~2.5GHz
Impedance
50 ohm
VSWR
2.0: 1 max.
Isolation
at least 20 dB
HPBW/H
33°
HPBW/V
32°
Polarization
Linear; vertical
Power handling
1 W
Peak gain
10 dBi
Temperature
• Operating –30 to 80° C (–22 to176° F)
• Storage –40 to 85° C (–40 to185° F)
Humidity
95% RH
Radome material
ABS
240 x 240 x 40mm
Dimensions (l x w x h)
(9.45 x 9.45 x 1.57 in)
Weight
700 gf (24.7 oz.)
Connector
N plug reverse x 2
Horizontal Radiation Patterns
30 cm Cable
Frequency range
0 to 3 GHz
VSWR
1.5 max.
Cable type
HPF 195 Harbour Industries
Transmission loss
2.2 dB max @ 2.4 – 2.5 GHz
Connector type
2 N type male reverse
Max. working voltage 250 Vrms min.
Minimum bend radius 25 mm (1 in.)
Jacket
FRPBC Black, 5 mm (0.195 in.)
diameter
Recommended
229 mm.kg* to 559 mm.kg*
coupling nut torque
(4.1 in.lbs to 10.0 in.lbs)
Coupling nut
22 kg* (50 lbs.) min.
retention force
Connector body and
Brass Per JIS H3250 C3604 BD, plated Temperature
contact
Insulation
PTFE Fluorocarbon per ASTM D 1710 Water proof
Temperature/RH
Storage and operating –40 to 75° C
(–40 to167° F)/ 20 to 95% RH
Water proof
Rain resistant
Vertical Radiation Patterns
Lightning Arrestor Specifications
Frequency range
DC~6GHz
VSWR
1.5 max.
Insertion loss
less 0.9dB
DC Spark Over Voltage
184-276V
100V/S
Gas Tube Insulation
10 G Ohm max.
Resistance At 100Vdc
Impedance
50 Ohms
Insulation resistance
2,000 Megohms
Capacitance 1MHz Pf
less 1
current
DC Holdover Voltage
135V
per ITU-T K.12
Connectors
N type female reverse
–40~85° C (–40 to 185° F)
Rain resistant
RoHS compliant
Yes
Technical Support
Thank you for selecting NETGEAR products. Locate the serial
number on the label of your product and use it to register your
product at www.NETGEAR.com/register. Registration is
required before you can use our telephone support service.
Registration via our website is strongly recommended.
Go to http://kbserver.netgear.com for product updates and Web
support. For Warranty and Customer Support information see
the Customer Support card that came with you product.
Statement of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves
the right to make changes to the products described in this document without notice. NETGEAR does
not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s)
described herein.
Federal Communications commission (FCC) Compliance Notice: Radio Frequency
Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
To comply with FCC regulations, the ANT32405 should only be used with devices that have been FCC
approved for use with the NETGEAR ANT32405. Check the NETGEAR website at
http://tools.netgear.com/legal/fcc_antennas.html for an updated list of FCC approved devices.
Note: This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving
antenna; (2) Increase the separation between the equipment and receiver; (3) Connect the equipment to
an outlet or circuit different from that to which the receiver is connected; (4) Consult the dealer or an
experienced radio/TV technician for help.
FCC and EU Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
To avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna must be less than 20 cm (8 inches) during normal operation.
This device should not be co-located with other transmitters.
For EU, use of any antenna requires careful planning and extra considerations to comply with EU
emissions and health standards and regulations. Antenna installation must comply with the maximum
level authorized by each country.
This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,
this product should be treated and recycled in accordance with the laws of your jurisdiction implementing
the WEEE Directive.
© 2009 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are registered trademarks of
NETGEAR, Inc. in the United States and/or other countries. Other brand and product names are trademarks or
registered trademarks of their respective holders. Information is subject to change without notice.
July 2009
Advertisement
