Related Manuals for Calortrans C50 II
Summary of Contents for Calortrans C50 II
- Page 1 C50 II Cap press Congratula� ons with your brand new Calortrans C50 II transferpress. A very good choice! As excited as you probably are to start using the machine, please take some � me to read through this manual.
-
Page 2: Safety
IMPORTANT SAFETY INSTRUCTIONS For safe use of the Calortrans C50 II Heatpress the following precau� ons should be taken. Before use: • Read the en� re manual before using the press • Use the press only for tex� le transfers or products suitable for sublima� on •... -
Page 3: Table Of Contents
table of content 2. safety 3. table of content 4. machine in detail 5. display in detail 6. preface 7. user manual 9. cer� fi ca� on 10. faq... -
Page 4: Machine In Detail
machine in detail lcd display set the � me and temperature Element Interchangable cap/ chest logo elements on/off switch switch the device on (0 is off 1 is on) Pressure knob adjust pressure here Gripper Lock cap in place to prevent movement... -
Page 5: Display In Detail
display in detail temperature actual temperature of the heat plate � mer Pieces countdown � mer (beeps when ready) counts the pieces menu plus minus click to set the increase or decrease temperature and � me temperature or � me... -
Page 6: Preface
This manual was made to make the usage of the Calortrans C-50 II Cap transfer press as easy and safe as possible. It is therefore recommended that you read this manual carefully and follow the instruc� ons step by step. -
Page 7: User Manual
user manual step 1. connect the power cord Check if the voltage is 230V before the machine is connected. The socket must be protected with at least 10 amps. Do not use an extension cable, this can cause overheat- ing of the power cable and / or loss of volt- age. - Page 8 Which � me and temperature se� ngs should you use? Every transfer has its own se� ngs regarding temperature, � me and pressure. For example: Calortrans turbofl ex on co� on (htv) is to be pressed at 150 ºC (302ºF) for 3-5 seconds. Please consult your transfer dealer for the recommended se� ngs.
- Page 9 5. changing heat element The Calortrans C-50II comes with a cap element and a chest logo element (15x15cm). Easily interchange the elements by the following steps. step 5b. remove powercord step 5a. switch off the machine step 5c. unscrew element cord step 5d .
-
Page 10: Cer� Fi Ca� On
cer� fi ca� on This product is RohS cer� fi ed RoHS is o� en referred to as the “lead-free direc� ve,” but it restricts the use of several Hazardous Substances This product is CE cer� fi ed. CE marking is a cer� fi ca� on mark that in- dicates conformity with health, safety, and environmental protec�... -
Page 11: Faq
This issue can be fi xed by fi lling up the garment with a Calortrans Tefl on pillow to redistribute the pressure. The press leaves a print on the garment.