Faq; Communication Range Is Too Short; Module Is Easy To Damage; Ber(Bit Error Rate) Is High - Ebyte E01-2G4M27SX User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

6. FAQ

6.1 Communication range is too short

The communication distance will be affected when obstacle exists.

Data lose rate will be affected by temperature, humidity and co-channel interference.

The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground.

Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea.

The signal will be affected when the antenna is near metal object or put in a metal case.

Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter the

distance).
The low voltage of the power supply is lower than the recommended value at room temperature, the lower the

voltage, the lower the power;
Due to antenna quality or poor matching between antenna and module.


6.2 Module is easy to damage

Please check the power supply to ensure that it is between the recommended power supply voltage, if exceeding the

maximum value will cause permanent damage to the module;
Please check the stability of power source, the voltage cannot fluctuate too much.

Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostatic

susceptibility.
Please ensure the humidity is within limited range, some parts are sensitive to humidity.

Please avoid using modules under too high or too low temperature.


6.3 BER(Bit Error Rate) is high

There are co-channel signal interference nearby, please be away from interference sources or modify frequency and

channel to avoid interference;
The clock waveform on the SPI is not standard. Check whether there is interference on the SPI line. The SPI bus

trace should not be too long;
Poor power supply may cause messy code. Make sure that the power supply is reliable.

The extension line and feeder quality are poor or too long, so the bit error rate is high;

Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd.
E01-2G4M27SX User Manual
8