Table of Contents
Advertisement
Firmware Upgrade
The 2X-M has the ability to upgrade the firmware over USB using a PC-based application. No
special tools are needed.
Firmware upgrades requires that the 2X-M be started in bootloader mode. Hold the 'INPUT'
button down while connecting the 2X-M to a PCB via USB cable. The LED indicator should
remain solid RED.
If the upgrade process fails, simply restart by powering off the device and re-entering the
bootloader. Since the bootloader resides in a protected region on memory on the
microcontroller, bricking the device is extremely unlikely.
To exit bootloader mode without upgrading, disconnect the microUSB cord from the 2X-M,
then reinsert without holding the 'INPUT' button down.
Detailed and firmware files may be found on www.retrotink.com.
THE 2X-M HAS A CUSTOM FIRWMARE BASE. DO NOT USE 2X-M FIRMWARE ON ANY
OTHER DEVICE OR VICE VERSA.
Copyright RetroTINK LLC 2020
Page
6
of
8
All Rights Reserved
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2X Pro Multiformat and is the answer not in the manual?
Questions and answers