Table of Contents
Advertisement
Initial Start-Up
General Instructions
Greater Goods' Body Fat Analyzer 0384 applies BIA (Bio-impedance Analysis)
technology. A small amount of weak current flows through the human body so as to detect
the bio-impedance and estimate BMI, body fat, body water and muscle mass. The electrical
current is small and may not be felt.
This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It also
possesses the characteristics of simple operation and abundant information.
The current mentioned above is less than 0.5mA. However, please be aware that anyone
with an wearable or implantable medical electronic instrument, such as a pacemaker, must
avoid using this device.
The intended use of this device is for healthy children 10-17 years old and healthy adults.
Insert the Batteries
Open the battery door in the back of the scale.
Insert the batteries (4 x 1.5V AAA) into the battery
compartment according to the polarity indications
marked inside the compartment.
* The digits " 8888 " will be shown on the LCD.
Close the battery door and wait until the digits "
are shown on the LCD.
CAUTION
When the symbol
and " Lo" appear, the device will power off. Then you shall replace with a new set
of batteries. Please replace all four batteries at the same time. Do NOT mix the old batteries with the new
one.
Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.
Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries
and scrapped device.
If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries
before storing.
6
"
Configure the Wi-Fi Password
1. Install the APP "Weight Gurus". This APP could be freely downloaded at the APP
Store, you may search and install it in your smartphone.
2. Turn on Wi-Fi and the APP. Make sure both are ON when pair-up is proceeding.
3. Then register an account, and follow these steps:
Note: Take the latest version of APP as the criterion.
4. Press and hold "UNIT" button in the back of the scale to start pair-up. Symbol "SETUP 1"
will be blinked on the LCD, indicating pair-up is proceeding.
5. Wait for the scale counts "SETUP 1" to "SETUP 1234", then display the user ID, and
finally display "STEP ON". At this time, it indicates that the scale has been successfully
distributed. Then you can start measuring.
Initial Start-Up
7
Advertisement
Table of Contents
