Table of Contents
Advertisement
Installation, Operation and Maintenance Manual
2 INSTALLATION
There is no intent on the part of Data Aire, Inc. to define local codes or statutes which may supersede common
trade practices. The manufacturer assumes no responsibility for their interpretation. Consult local building codes
and National Electrical Code (NEC) for special installation requirements.
Recommended Tools for Installation
Wrenches – Common sizes
Flat tip and Phillip screwdriver – Common sizes
Wiring tools
Brazing tools
Multi-meter
Pressure gauges – Sized for design pressure
Electric hand tools
Equipment handing
Safety items
Leveler
Pre-Installation
The unit you have received is specifically designed for indoor environmental control. This unit is designed and
intended to be installed indoors in a conditioned space unless otherwise noted on the equipment serial name plate.
Compare the data on the nameplate of the air-conditioning unit and other modules with the packing list and the
order documents.
Backdraft dampers should be considered if multiple units are being installed with a common duct system. On floor
units with plug fans, there is an AirSeal feature that will act as a virtual backdraft damper by running the fans at
minimal speed. A damper or AirSeal will prevent cold air from flowing backwards through a unit that is offline or in
standby.
CAUTION
Risk of handling heavy and lengthy parts, risk of top-heavy unit falling
over, risk of sharp edges, splinters and exposed fasteners; can cause personal
injury and equipment damage. Cabinet doors and panels can weigh more than
35lb. (15.9kg) therefore follow relevant OSHA lifting recommendations and
consider using a two-person lift for safe and comfortable removal and
installation of cabinet doors and panels.
NOTICE Only properly trained and qualified personnel wearing
appropriate safety headgear, gloves and shoes should attempt to
remove or install cabinet doors and panels.
Page 3 of 100
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the gPod and is the answer not in the manual?