Advertisement
Quick Links
Read instructions completely
before starting.
Follow steps 1 through 11 for system
installation. Steps A through F on page 6 are
the RS-1SG purification cartridge replacement
instructions. An order form is included for
assistance in obtaining replacement RS-1SG
purification cartridges, and system parts.
Configuration dimensions are shown on page
8 at the end of this guide.
General Ecology, Inc.
Seagull IV X-1F and Seagull IV X-1B drinking
water purification systems are designed
to operate at pressures ranging from 25 to
125 psi. If pressure surges are a possibility
(municipal water supplies), install a Pressure
Regulator or Surge Protector on the cold
water supply line. This system is intended
to be installed to the cold water supply line,
downstream of and above the cold water
shut-off valve inside the kitchen sink cabinet.
(see illustration on pages 2 and 3)
Be sure to close water supply valves before
installation. The Connector Hose will fit an
Owner Supplied Connector T or optional
stainless steel Compression T (part number
714358) shown on page 2. Connector branch
of Owner Supplied Connector T must have
a
" male Compression thread (
thread). The cold water supply line should be
clean and free of construction debris. A
½
" diameter hole is necessary for mounting
1
the easily installed FP Faucet furnished with
this unit.
h
" - 24
p
" to
supersedes 200712D
Advertisement
Related Manuals for GENERAL ECOLOGY SEAGULL IV X-1F
Summary of Contents for GENERAL ECOLOGY SEAGULL IV X-1F
- Page 1 Read instructions completely Seagull IV X-1F and Seagull IV X-1B drinking Be sure to close water supply valves before installation. The Connector Hose will fit an before starting. water purification systems are designed Owner Supplied Connector T or optional to operate at pressures ranging from 25 to Follow steps 1 through 11 for system 125 psi.
- Page 2 RS-1SG Purification Cartridge 788000 Compression Cap Nut with X-1 Pressure Vessel Gasket 800349 Gasket Housing Dark Blue 710540 ” x ” x ” Stainless Steel Compression T 714358 V-Clamp for Housing 710534 General Ecology, Inc. — 2 Made in USA...
- Page 3 Mounting Bracket Kit with 700063 Wing Nut for V-Clamp 710032 2 screws (Residential) Gasket Cartridge Dark Blue 710553 Bracket Mounting Clip with 700060 3 screws (RV/Marine) Manufactured by General Ecology, Inc., Exton, PA 19341 Made in USA General Ecology, Inc. — 3...
-
Page 4: General Installation Instructions
Please retain for future servicing of your SEAGULL ® IV Water Purifier Preliminary: If needed, purchase from local hardware store and install Connector T (available from General Ecology) or Saddle Valve with a ” compression outlet in cold water supply line. - Page 5 Installation of SEAGULL IV X-1F & X-1B Systems Figure Figure Seagull IV systems are intended to be installed in the cold water supply line, water flow - in from water flow - out downstream of and above the cold water...
-
Page 6: Cartridge Replacement Instructions
Zip: __________ Phone: ( ______ ) _______________________________ (Circle One) must be filled in Charge my: VISA MasterCard American Express Send To: General Ecology, Inc. 151 Sheree Blvd. Exton, PA 19341 U.S.A. Expiration Date Signature www.generalecology.com General Ecology, Inc. — 6... - Page 7 X-1P PUMP X-1P PRESSURE VESSEL 3.5” (8.9 cm) 8.9” (22.6 cm) 3.5” (8.9 cm) 10.5” (26.7 cm) 2.5” (6.4 cm) 5.4” (13.7 cm) 2.9” (7.3 cm) 4.1” (10.5 cm) 5” (12.7 cm) 1.3” (3.2 cm) General Ecology, Inc. — 7...
- Page 8 (Actual Size) (610) 363-7900 • fax (610) 363-0412 • www.generalecology.com © 2004 General Ecology, Inc. • ®, ™ Trademarks of General Ecology, Inc. General Ecology, Inc. — 8 All health claims not in accordance with local or state laws are hereby withdrawn. • 200712E 0013...