Advertisement
1. Take off the shelter and press the switch.
2. Softly touch your skin and move in the contrary growth
direction of beards slowly.
- If you stretch your skin tightly, you can obtain better effect.
3. Once the shaving is over, push the switch down at once and cover it with the
shelter.
NOTE: C harging time can't exceed 15 hours or it affects the life of battery, even
damages the line.
Trimmer
1. Open the back cover and pull off the trimmer.
2. Softly touch your skin in the right-angle direction with the trimmer and trim
slowly.
3. After using, push down the switch and cover it with the shelter.
4. Press the switch and take off the shelter. Press the outer-cutter button and take
off the outer cutter. Clean the beards on the outer cutter, the inner cutter and
the body (1 time a week).
5. After cleaning, assemble the outer cutter and the inner cutter on the original
position and cover it with the shelter.
● Don't press the net shelter.
● Don't prizes open the net shelter with a screw with a screw driver.
● Do not change the positions of A B C heads and the directions of net cover
so as to avoid the affection to the normal operation of razor.
1. Remove the protective cover of the grid
2. Press the button (located under the head) to separate the shaver head and
body.
3. Also press the button on the back of the unit to remove the trimmer.
4. Remove the beard hairs with the brush provided and, if necessary, use a damp
cloth to clean the body.
5. After cleaning, reassemble the razor head with body in accordance with the
initial position and place the trimmer on the original position.
6. Replace the cover.
Before cleaning, always: switch off the appliance, disconnect the apparatus and
let it cool.
Clean the outside of the apparatus with a sponge or slightly wet linen.
Never plunge the apparatus in water or all other liquid!
Do not use abrasive cleaners, gritting, or metal brush or another cutting object.
CLEANING AND MAINTENANCE
STORAGE
7
Advertisement
