Change The Set Temperature; Run Spa Devices - Balboa TP700 User Manual

12
Main Screen
A
B
C
D
E
F
Heater On Heater Off
Note: the Heater Status icon flashes
during heater start-up; this is normal.
Balboa Water Group | Your Single Source Solution
CHANGE THE
SET TEMPERATURE
Follow these steps to change the Set Temperature:
1 - Start at the Main screen (A). Press the SELECT
navigation button to view the temperature menu (E).
2 - Press the RIGHT and/or LEFT navigation buttons to

change the Set Temperature.

The center box (D) indicates the current Set
Temperature. In this example the current Set
Temperature is 102.
3 - Once your desired Set Temperature is in the center
box (D), press the SELECT navigation button, or just
wait a few seconds.

The change is complete.
How do I view the Water Temperature?
The Water Temperature is displayed here (B) on the
Main screen.
How do I view the Set Temperature?
Start at the Main screen (A), and press the SELECT
navigation button. The Set Temperature is displayed in
the center box of the temperature menu (D).
How do I know when the water heater is On?
The center of the Heater Status icon turns red (C) when
the heater is On, and it turns white when the
heater is Off.
What do the dashes indicate (F)?
When the spa is powered On, four dashes appear
(F) in the Water Temperature display for one minute.
The dashes indicate that the spa is checking the
water temperature. After the pump runs for 1 minute,
the dashes disappear and the water temperature is
displayed (B). The dashes may reappear after the pump
has not run for one hour.

RUN SPA DEVICES

A
There are two ways to run
spa devices.
#1 - Run spa devices by pressing any of
these buttons (G).
#2 - Run spa devices from the Spa screen by
following these steps.
B
1 - Navigate to the Spa menu (A).*
C 2 - Press the SELECT navigation button to view the
Spa screen (B). Each icon (D) shown in the Spa screen
represents a spa device.
3 - Select Jets 1 (E). When you select an icon, its name
D
appears at the top of the screen (E).
4 - Press the SELECT navigation button to run
the spa device.
The spa device is running.
E
If you want to navigate back to the Main screen, select
the Back button (C) and press the SELECT navigation
F
button. The Main screen will appear.
The functionality of each spa device may vary. For
example, some devices may have a single speed or
state, while other spa devices may have multiple speeds
or states. Your spa configuration will determine the
number of spa devices and the functionality of
each device.
Spa Device Buttons
One Spa screen (B) can display a maximum of six
G
devices. If your spa has more than six, a menu arrow
will appear (F). Press the RIGHT navigation button to
view and/or run the other spa devices.
13

* View page 10 for information on navigating the Settings menu.
TP700 USER GUIDE 42370 Rev A