Sensor-Related Messages; System-Related Messages - Balboa TP700 User Manual

32
PANEL MESSAGES

SENSOR-RELATED MESSAGES

Control System
Temperature
Sensor
A
Sensors are out of sync
Message Code: M015 *
The temperature sensors may be out of sync by 3°F.
Call for Service if this message does not disappear
within a few minutes.
Sensors are out of sync **
Message Code: M026 *
The temperature sensors ARE out of sync. The fault
above has been established for at least 1 hour.
Call for Service.
View page 39 for instructions on how to review the Fault Log that corresponds with the Message Code.
*
This message can be reset from the panel using the CLEAR button (see page 31).
* *
Balboa Water Group | Your Single Source Solution
(Continued)
Temperature
Sensor
B
Sensor A Fault, Senor B Fault
Sensor A: Message Code: M031 *
Sensor B: Message Code: M032 *
A temperature sensor or sensor circuit has failed.
Call for Service.

SYSTEM-RELATED MESSAGES

Control System
Program memory failure **
Message Code: M022 *
At Power-Up, the system has failed the Program
Checksum Test. This indicates a problem with the
firmware (operation program) and requires a
service call.
The settings have been reset
(Persistent Memory Error) **
Message Code: M021 *
Contact your dealer or service organization if this
message appears on more than one power-up.
The clock has failed **
Message Code: M020 *
Contact your dealer or service organization.
Configuration error
The spa will not Start Up. Contact your dealer or
service organization.
View page 39 for instructions on how to review the Fault Log that corresponds with the Message Code.
*
This message can be reset from the panel using the CLEAR button (see page 31).
* *
33
The GFCI test failed
(System Could Not Test the GFCI)
Message Code: M036 *
(North America Only) May indicate an unsafe
installation. Contact your dealer or service organization.
A pump may be stuck On
Message Code: M034 *
Water may be overheated. POWER DOWN THE SPA.
DO NOT ENTER THE WATER. Contact your dealer or
service organization.
Hot fault
Message Code: M035 *
A Pump Appears to have been Stuck ON when spa
was last powered POWER DOWN THE SPA. DO NOT
ENTER THE WATER. Contact your dealer or
service organization.
TP700 USER GUIDE 42370 Rev A