Settings - Balboa TP700 User Manual

28

SETTINGS

A
B
* View page 10 for information on navigating the Settings menu.
Balboa Water Group | Your Single Source Solution
Fine tune your spa with a wide
variety of Settings
Navigate to Settings (A) to view and/or control your spa. *
This is an example of a Settings list (B). Your Settings list
may vary.
HEAT
Make sure your spa is heated and ready to enjoy with Heat
Settings (view page 20).
TIME
Set the Time to insure scheduled features have proper
timing (view page 11).
REMINDERS
Reminders (A) are helpful spa maintenance messages that
display periodically.
LOCKS
Lock the Panel and/or Settings (view page 16).
FILTER
Keep your spa water clean and ready to enjoy by setting
Filter Cycles (view page 14).
HOLD
Hold is used to disable the pumps during service functions
like cleaning or replacing the filter. Hold Mode will typically
last for 1 hour unless the mode is exited manually. You can
see how much longer Hold will last at the bottom of the
screen (for example, "Holding for 0:58"). If you Exit this
screen, Hold Mode ends.
If spa service will require more than an hour, it may be best
to simply shut down power to the spa.
Drain Mode (Optional)
Some spas have a special feature that allows Pump 1 to be
employed when draining the water. When available, this
feature is a component of Hold.
CLEANUP CYCLE (Optional)
C
When a pump or blower is turned On by a button press,
a Cleanup cycle begins 30 minutes after the pump
or blower is turned Off or times out. The pump and
the ozone generator will run for 30 minutes or more,
depending on the system. You can change this setting
on some control systems.
If Cleanup is set to zero hours, this feature
will be disabled.
Cleanup is not included with all control systems, and control of
Cleanup is not included with all control systems that have Cleanup.
D UNITS
Specify Time and Temperature Units (C). The
temperature choices are Fahrenheit or Celsius. The
time display choices are 12 hour or 24 hour.
LANGUAGE
Select from a variety of languages (D).
PANEL
Set how long it takes the panel to go to sleep after the
last activity. The default is 30 minutes (F).
E
Turn On/Off the panel lights (G).
Control the brightness of both the panel lights and the
panel display together (H).
F
G
DIAGNOSTICS
Spa technicians can find useful information and
features in Diagnostics (view page 38).
H
TP700 USER GUIDE
29
42370 Rev A