Table of Contents
Advertisement
Hold Drill to program on which steps the drill will work by toggling
bottom pads on or off. Release Drill to confirm.
Hold a bottom pad to rapidly repeat the corresponding track for a drill
effect. The rotary encoder sets the repeat rate
4.5 Rate
Each track can run at different speeds. Press a lower pad to change
the speed of the selected track.
Hold shift to change the rate of all tracks at once.
4.6 Swing
You can add swing to any track using pads 1 to 8.
Hold shift at the same time to apply swing to all tracks at once.
4.7 Copy
In copy mode, press a lower pad to copy its corresponding track to the
memory clipboard.
Hold shift and press the 6th upper pad (copy) to copy all tracks to the
memory clipboard at once.
Tip: Accents are copied too.
Twisted-Electrons.com
Advertisement
Table of Contents
