2 Application and short description The MU100W measuring transducer converts the position of a potentiometer into a linear signal 0/4- 20 mA respectively 0-10 V. Zero can be easily scaled 0...40 %, Full-scale 60 ... 100 % of the range of the potentiometers by pressing a button.
Instead of the industrial norms and regulations written in this instruction manual valid for Europe, you must observe out of their geographical scope the valid and relevant regulations of the corresponding country. MU100W 12100-0703-00 Page 3 / 6...
To switch the current output to 0…20 mA, press and hold the zero button for approx.. 5s until the yellow LED 4…20 mA goes out. The voltage output is always set to 0…10 V independent of the current output. 7.5 Factory setting The current output is factory set to 0…20 mA. MU100W 12100-0703-00 Page 4 / 6 www.ziehl.de...
Protection class housing / terminals IP 40 / IP20 Standard rail 35 mm Mounting EN60715 M4, only with additional bolt (not part of delivery) Optional: screw mounting approx. 130 g Weight Subject to technical modifications MU100W 12100-0703-00 Page 5 / 6 www.ziehl.de...
Plombenlasche / latch for sealing Frontplatteneinsatz / front panel Kennzeichen für unten / position downward Riegel bei Wandbefestigung mit Schrauben. Riegelbohrung Ø 4,2 mm / for fixing to wall with screws, Ø 4,2 MU100W 12100-0703-00 Page 6 / 6 www.ziehl.de...