Table of Contents
Advertisement
Faults
The drying result is not
satisfactory (washing is
not dry enough).
When the door is opened,
you will notice that a small
amount of water drips
onto the dried washing.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
Set programme selector to Off and pull out the mains plug.
■
Turn off the tap and call customer service. ~ Page 36
■
Cause/Remedy
Excessively high ambient temperature (above 30 °C) or inadequate ventila-
■
tion in the room in which the washer dryer is situated. Ensure adequate ven-
tilation to allow surplus heat to escape.
The washing is not adequately spun before the drying phase. Always select
■
the maximum selectable spin speed for the particular washing programme.
Washer dryer overloaded: Observe the recommendations for the maximum
■
load in the programme table and on the load display. Do not overload the
washer dryer, as the maximum load for the drying phase is less than the
maximum load for the wash cycle. Unload the washer dryer after washing
with the maximum load and divide the washing into two drying cycles.
The power supply voltage is too low (below 200 V) – provide a suitable
■
power supply.
Air filter blocked? ~ Page 31
■
Thick, multi-layered textiles or textiles with thick padding – dry these gently
■
on the surface but not on the inside. Balancing may take longer. For these
types of textiles select the time drying programmes.
The drying time is reduced for a smaller load. Some residual moisture may
■
remain in the dryer system. If the door is opened quickly, a suction effect is
generated which causes the moisture to drip out of the dryer system.
Open the door slowly. Avoid wrenching the door open.
■
Faults and what to do about them
en
35
Advertisement
Table of Contents
