Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Status display xflashes.
Foam may come out of
the detergent drawer.
Loud noise formation,
vibrations and "wander-
ing" during spin cycle.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
The programme duration
changes during the wash
cycle.
Detergent residue on the
washing.
Spin noise during the dry-
ing phase.
Varicoloured fluff from the
previous drying cycle is
deposited on the washing
during the subsequent
wash cycle.
Water inlet noise during
the drying phase, tap sym-
bol flashes during the dry-
ing phase.
Drying duration extended.
Drying programme does
not start.
34
Cause/Remedy
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care product which are
suitable for washer dryers.
Appliance aligned? Align the appliance. ~ Page 43
■
Appliance feet fixed? Secure appliance feet. ~ Page 43
■
Transportation protection devices removed? Remove transportation pro-
■
tection devices
Power failure?
■
Fuse tripped? Switch on/replace fuse.
■
If the fault occurs repeatedly, call customer service. ~ Page 36
■
Not a fault – unbalanced load detection system adjusts imbalance.
■
Not a fault – foam detection function active. Additional rinse cycle.
■
Occasionally phosphate-free detergents contain water-insoluble residue.
■
Select Spin/Rinse (should be drained only: rpm (spin speed) set to $) or
■
brush items after washing.
This is an innovative process known as thermal spinning in order to reduce
energy consumption during the drying phase.
Run the Drum Clean programme without washing to remove fluff which has
collected in the washer drum during the drying phase.
The washer dryer runs a self-cleaning cycle to remove fluff which was deposited
by the washing during the drying phase. This requires a little water. Therefore,
turn the tap on even during the drying phase.
According to the principle of air cooling a higher ambient temperature
■
results in a lower drying effect, thereby extending the drying duration.
Ensure good ventilation to allow surplus heat to escape.
Air filter blocked? ~ Page 31
■
Run the Drum Clean programme to remove fluff which has collected in the
■
washer drum during the drying phase.
Drying programme not selected?
■
Door not closed properly?
■
Pump blocked?
■
Advertisement
Table of Contents
