Table of Contents
Advertisement
Problem
Non-PoE IP camera does not have
power. (12VDC output model
equivalent)
What is the maximum transmission
speed of the equipment?
Check the power LED status of Tx EPoC. If the blue LED is not turned on, it
could be faulty transmission media or cause of cable length or power
consumption of the end-device, or a faulty DC power input. If the blue is on,
check the DC OUT switch is On and DC OUT LED status next.
If the DC OUT switch is OFF and the DC OUT LED is blinking, check that the DC
OUT switch is ON and the DC OUT LED is green, since the IP camera can not
powered by 12VDC output.
If red light on the power quality LED is on, 48~57VDC power from Rx EPoC is
being measured by Tx EPoC to be less than 40VDC due to distance reasons, IP
camera cannot be powered by 12VDC output feature.
EPoC Device supports maximum 270 Mbps full duplex.
However, the IEEE 1901 Standard for EPoC devices is designed to reduce
the transmission rate as the distance increases. Please refer to the
transmission rate for each transmission distance.
Troubleshooting FAQ — 20
Action
Advertisement
Table of Contents
