Hose Connections - Steinbach Classic 250N Original Owner's Manual

4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
The base plate is connected to the filter vessel.

Hose connections

- Fasten all attached hose connections with hose clamps to ensure that the system
does not leak.
We recommend additionally sealing the hose connections with Teflon tape
- Use suitable pool hoses for the described connections.
Some hoses, such as the pressure hose, are very stiff. Place them in the sun
before use so that the heat makes them more flexible.
Connecting the return line
You can use hoses with diameters of 32 or 38 mm or an INTEX Pools/Speed
Clean
1. Press and hold down the valve lever
2. Set the valve lever to the "CLOSED" position and release it.
3. Connect one end of the hose to the "RETURN" connection on the valve head
- Attach a hose with a 32 mm diameter to the "RETURN" connection and fasten it with
a hose clamp.
- Screw the INTEX Pools/Speed Clean
line on the valve head
21
- Slide a hose with a 38 mm diameter over the thread up to the stop of the "RETURN"
connection and fasten it with a hose clamp.
4. Connect the second end to the connection on the injection nozzle of the pool.
The return line
21
Connecting the pressure line
1. Attach one end of the pressure hose
2. Place a hose clamp
turn the screw on the hose clamp clockwise to tighten the hose clamp over the
connection.
3. Place the second hose clamp over the pressure hose.
4. Attach the end of the pressure hose to the "PUMP" connection on the valve head
40
to the filter vessel
9
return line adapter.
26
.
1
is connected.
over the pressure hose. Using a Phillips screwdriver PH1
12
.
2
on the valve head
23
return line adapter clockwise onto the return
26
to the top pump connection
11
15
.
1
.
3
.
.
1
,
24
.
1