Troy-Bilt TB425 XP Operator's Manual page 8

WARNING:
Unless specified otherwise, the release
button should be snapped into the primary hole only. Using
the wrong hole could lead to personal injury or damage to
the unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler (Fig. 3).
3. Press and hold the release button (Fig. 5).
4. Pull the attachment straight out of the coupler (Fig. 4).
INSTALLING AND ADJUSTING THE HANDLE
Installing the Barrier Bar
1. Align the two pegs on the barrier bar with the two holes in the
handle (Fig. 6).
2. Press the barrier bar into the handle until the barrier bar snaps
into place.
3. Insert the barrier bar screw into the handle (Fig. 6).
4. Use a medium flat-head screwdriver or a T-20 Torx® screwdriver
to tighten the barrier bar screw until the barrier bar is secure.
Installing the Handle
1. Use a large flat-head screwdriver or a T-25 Torx screwdriver to
remove the four (4) screws and bottom clamp from the handle
(Fig. 8).
2. Place the handle onto the top of the upper shaft housing (Fig. 8).
Make sure the barrier bar is on the left (Fig. 8) when holding the
unit in the operating position (Fig. 17).
3. Align the bottom clamp below the upper shaft housing and
handle. Hold the handle and bottom clamp together.
4. Insert the four (4) screws through the handle and into the bottom
clamp.
5. Use a large flat-head screwdriver or a T-25 Torx screwdriver to
tighten the screws until the handle and bottom clamp are held
together. Do not tighten the screws completely.
6. Hold the unit in the operating position (Fig. 17). Move the handle up
or down the upper shaft housing to a comfortable location. Make
sure the handle is positioned between the two arrows (Fig. 7).
7. Tighten the screws until the handle is secure.
Adjusting the Handle
If the handle requires adjustment:
1. Use a large flat-head screwdriver or a T-25 Torx screwdriver to
loosen the 4 screws in the handle (Fig. 8).
2. Hold the unit in the operating position (Fig. 17). Move the handle up
or down the upper shaft housing to a comfortable location. Make
sure the handle is positioned between the two arrows (Fig. 7).
3. Tighten the screws until the handle is secure.
Primary Hole
Barrier Bar
Screw
Barrier Bar
Arrows
Handle
Shaft Grip
8
Release Button
Guide Recess
Fig. 5
Handle
Fig. 6
Fig. 7
Screws
Barrier Bar
Upper Shaft
Housing
Bottom Clamp
Fig. 8