Troubleshooting - Kalorik TKG AP 2000 S Manual

SPEED – Press this button to adjust the engine speed: low (500 RPM), medium
(700 RPM) or high (900 RPM) and exit the automatic mode. The engine
speed will no longer be controlled by the sensor.
REMOTE CONTROL
The air purifier is equipped with a remote control:
• The buttons on the remote control and the corresponding buttons on the control
panel work exactly the same way.
• There is an additional unlock button on the remote control.
• If you do not use the remote control for a long period of time, remove the battery.
TIME SETTING
Setting method:
1. Press and hold the AUTO button for a long time to access the time settings.
2. First the hours will flash: press 'Speed' and 'Sleep' to set the time and then press
AUTO.
3. Then the minutes will flash: press 'Speed' and 'Sleep' to set the minutes and press
AUTO.
Note: The time of the unit works completely independently, the time displayed does not
affect purification.

TROUBLESHOOTING

Problem
The device does not switch
on or the key does not
respond.
The air is polluted but the
indicator remains green.
Even after continuous use the
indicator remains red.
The device is noisy.
The smell from the air outlet is
unpleasant.
The purifier works but seems
to have no effect on air
quality.
The display shows "F1" or
"F2"
Solution
• Check that the unit is properly connected.
• Check that the front panel is securely in place.
• Check that the childproof mode is disabled.
• Check that the unit is installed on a flat surface.
• Make sure that the unit is placed in a place with
good air circulation.
• Check that the particle sensor is clean.
• Check that the negative ion generator is not
dusty.
• During the night, make sure that the sleep mode
is activated.
• Clean the filter if it is dirty.
• Replace the filters if necessary.
• Check that the filter packaging is removed.
• Check that the filters are installed in the correct
order and direction.
• Unplug the unit immediately and call for service.
11
TKG AP 2000 S