Seasonal Maintenance; Start Of Season; End Of Season - Lindsay GrowSmart Multi-Control Operation Manual

Alert
High Rainfall Warning
Communication Warning
Low pH Warning
High pH Warning
Irrigating
Chemigating
Plan Paused
Injector Off for Filter Flush Delay
Filter Flush Cycle Running
Powered Off Normal
Temperature Protection Plan Running
Plan Running
Post-Filter Pressure Delay

Seasonal Maintenance

Start of Season

• Check for damaged wires and/or loose electrical connections. Contact a Lindsay Dealer for any wire replace-
ment.
• Make sure the solar panel is tilted to the optimum angle and direction for direct sunlight.
• Make sure the solar panel is clean.
• Remove debris from the rainfall collection bucket.

End of Season

• Store all rechargeable batteries in a cool, ventilated area, away from heat and open flame. Cover the battery
terminals to avoid accidentally creating a circuit due to exposed battery terminals.
• Turn off all wireless switches.
P/N 1604010 Rev D (ECN 35207)
Default Level
2- Medium Rainfall accumulation in the rain bucket is nearing
the programmed limit.
2- Medium FieldNET can communicate with the RTU but not
with the Multi-Control. This would indicate a loose
or severed serial cable connection.
2- Medium The pH limit is falling close to the programmed low
limit.
2- Medium The pH limit is increasing close to the programmed
high limit.
3- Low The Multi-Control is irrigating.
3- Low The Multi-Control is chemigating.
3- Low The current plan is paused.
3- Low Chemigation is temporarily stopped for a filter flush
cycle.
3- Low The filter flush cycle is running.
3- Low The Multi-Control is properly powered off.
3- Low A temperature protection cycle is running.
3- Low The current plan is running.
3- Low The post-filter pressure alerts are temporarily being
ignored due to the system building up pressure.
3-3
Cause
Multi-Control Operation Manual
Section 3 - Service