Lindsay GrowSmart Multi-Control Operation Manual page 24

Alert
Filter Hardware Error
Zone Hardware Error
High System Flow Warning
Low System Flow Warning
High Flow Disparity Warning
Low Flow Disparity Warning
High System Pressure Warning
Low System Pressure Warning
High Post-Filter Pressure Warning
Low Post-Filter Pressure Warning
High Temperature Warning
Low Temperature Warning
High Injector Flow Warning
Low Injector Flow Warning
High Voltage Warning
Low Voltage Warning
Wireless Switch Battery Warning
Maximum Filter Flush Cycles Warning
Stopped
Pressure Startup Delay
Flow Delay
Injector Flow Delay
Wireless Switch Communication Warn-
ing
P/N 1604010 Rev D (ECN 35207)
Default Level
2- Medium One of the filter flush valves is reporting a problem
which may impact filter flush cycles.
2- Medium One of the wireless switch zone valves is report-
ing a problem which may impact irrigation plans or
temperature protection.
2- Medium System flow is reaching the programmed high limit.
2- Medium System flow is reaching the programmed low limit.
2- Medium Possible a leak or broken pipe; the system flow is
higher than expected, compared to the total for all
the zone application rates.
2- Medium Possible stuck valve or drip tape is plugged; the
system flow is lower than expected, compared to
the total for all the zone application rates.
2- Medium System pressure is nearing the maximum limit.
2- Medium System pressure is nearing the minimum limit.
2- Medium Pressure in the line, past the filter is nearing the
maximum limit.
2- Medium Pressure in the line, past the filter is nearing the
minimum limit.
2- Medium Temperature is nearing the maximum limit.
2- Medium Temperature is nearing the minimum limit.
2- Medium Flow through one of the injectors is nearing the
maximum limit.
2- Medium Flow through one of the injectors is nearing the
minimum limit.
2- Medium System voltage is nearing the maximum allowable
voltage.
2- Medium System voltage is nearing the minimum allowable
voltage.
2- Medium One of the wireless switches is reporting problems
with the battery power.
2- Medium The Multi-Control has attempted the maximum
number of contiguous filter flush cycles to reduce
differential pressure.
2- Medium The Multi-Control has stopped operating.
2- Medium The system pressure alerts and shutdown condi-
tions are temporarily being ignored due to the
system pressurizing at startup.
2- Medium The system flow alerts and shutdown conditions are
temporarily being ignored due to the system build-
ing up flow at startup.
2- Medium The injector flow alerts and shutdown conditions are
temporarily being ignored due to the system build-
ing up flow at startup.
2- Medium One of the wireless switches has low signal
strength or data loss.
3-2
Cause
Multi-Control Operation Manual
Section 3 - Service