Section 4 - General Setup And Installation Notes Button Actions; Manual Select Levels - Gavita Euroquatics Angel A1 User Manual

Section 4 - General Setup and Installation Notes
Button Actions
The Configuration Button is your one physical interface with the Angel system. It allows you to link/pair fixtures in the
Euronet network, access the WPS feature for WiFi, do factory resets, and access the Manual Select feature.
Function WiFi Mode
Manual select Any
RF Pair Any
WiFi Pair Access point
Switch WiFi - WPS
between WiFi
Access point
and AP
Factory reset N/A

Manual Select Levels

Manual Select is only available at the beginning of set up process. Once you've accessed the device via a WiFi
connection, the manual selection will no longer work. Once you've selected a manual level you can connect the
fixture(s) to a simple timer and it will retain that setting as power is switched on and off. This is a feature that allows
very fast set up and installation if you do not have time to configure the system any other way.
Number Name
1 100%
2 50%
3 10%
4 20K
5 15K
6 12K
7 10K
8 ALL OFF
Button
LED New mode
sequence
Tap ( < 1
-
second )
On Hold 2s RF Pairing
On Hold 4s WiFi pairing mode
Access point
On Hold 8s
WiFi - WPS
Hold during
- Factory reset
boot
Discription
All LEDs at 100% on
All LEDs at 50% on
All LEDs at 10% on
The fixture has a 20K look, very blue, rich color to make your "coral pop"
The fixture has a 15K look with a soft blue feel
The fixture has a 12k look that is a bit warmer and contributes more to coral growth
The fixture has a 10k look with a true warm color very nice for coral propagation
The fixture is all off
LED Timeout
- Blink once -
Flash rapid
30sec
(Fading)
Flash slowly
60sec
(Fading)
- -
Flash rapid
-
(fading)
21
Success Fail
Next pre-set setting -
Slow blink LED 5s Rapid blink LED 5s
WiFi mode, Slow Acces point, Rapid
blink LED 5s blink LED 5s
Slow blink LED 5s Rapid blink LED 5s
Slow blink LED 5s Rapid blink LED 5s