Eurolux ECH2 TC4 FV Installation Manual page 97

If the heat boost is required, it can be
activated by pressing
setting is set to level 9. In the heat
display "A/9"
Switching Off Individual Heaters
A heater can be switched off in 3 diff er-
ent ways:
• Simultaneous pressing of
buttons
• Reduction of the heat setting to "0" by
pressing the
• Use of the timer switch-off function for
the corresponding heater.
Simultaneous operation of
buttons
The corresponding heater must be cho-
sen with the Activate/Deactivate Heater
Button , the Decimal Point of the re-
lated Heater Display will then fl ash. To
switch off the heater,
be pressed simultaneously. A buzzer will
sound and "0" will appear in the heat set-
ting display when this is successful.
If the timer is active for the selected heat-
er, then "0" will appear in the heater and
timer displays, and the related Cooking
Zone Indicator and the Timer Function
will both switch off .
If there is any residual heat for the heat-
er, this will be indicated by a "H" in the
heat setting display.
Reduction of the heat setting to "0"
by operating
The heater can also be switched off
by reducing the heat setting to "0".This
causes the associated Decimal Point
of the heater, the related Cooking Zone
Indicator and the Timer Display to all
switch off , also.
. If the heat
and
button
and must
button
If there is any residual heat for the heat-
er, this will be indicated by a "H" in the
heat setting display.
Use of timer switch-off function for
corresponding heater (if available)
After counting down to zero, the timer
will stop. The corresponding heater will
show "0" in the Heater Display and the
Timer Display will show "00". The cor-
responding Cooking Zone Indicator will
disappear.
An assigned Dual/Triple Zone Selection
Indicator will also disappear if it is active.
The buzzer will also sound when the tim-
and
er stops. Pressing any button will silence
the timer.
Timer Function
The timer provides following features:
The control can run all heater assigned
timers and 1 minute minder (which is not
assigned to a heater) simultaneously.
All timers can only be used in B-Mode.
A heater timer can only be assigned to
an active heater, set at a level between
1-9. The minute minder is independent
of any heater.
In order to use both functions, the timer
function must be activated using the
Activate/Deactivate Timer button
Touching
activating the heaters, controls the mi-
nute minder (no Cooking Zone Indicator
is fl ashing, they are all on or off ).
Touching
timer to one of the activated heaters. The
Cooking Zone Indicator will be fl ashing.
Touching
timer in a clockwise direction to the next
active heater. And so on...
97
for the fi st time after
for a second time, assigns a
again, assigns the next
EN
.