Advertisement
The equipment is marked with the WEEE symbol shown to indicate that it must
be collected separately from other types of waste. In case of small items the symbol
may be printed only on the packaging or in the user manual. If you have questions
regarding the correct disposal of equipment go to www.omniton-systems.com/support
or e-mail to Omnitron at intlinfo@omnitron-systems.com.
Safety Warnings and Cautions
ATTENTION: Observe precautions for handling electrostatic discharge sensitive
devices.
WARNING: Potential damage to equipment and personal injury.
WARNING: Risk of electrical shock.
CUSTOMER SUPPORT INFORMATION
Phone:
(949) 250-6510
Fax:
(949) 250-6514
Address:
Omnitron Systems Technology, Inc.
38 Tesla
Irvine, CA 92618, USA
Email:
support@omnitron-systems.com
URL:
www.omnitron-systems.com
Page 3
iConverter T1/E1
User Manual
Product Overview
iConverter
The
T1/E1 media converter provides standard T1 (1.544Mbps) or E1
(2.048Mbps) copper to fiber conversion and can be used to extend the demarcation
point between service provider and networking equipment. T1/E1 media converters
operate in pairs, extending distances over fiber, which improves noise immunity, quality
of service, intrusion protection and network security.
The T1/E1 supports Small Form Pluggable (SFP) transceivers, enabling adaptability to
different fiber types, distances and wavelengths, providing maximum flexibility across
a variety of network architectures and topologies.
Management of the plug-in module is accomplished by using a M2/M3/M4 series
iConverter
Management Module, such as an
provides monitoring, configuration and trap notification.
Installation Procedure
1) Configure DIP-Switches
2) Install Module in the Chassis and Connect Cables
3) Verify Operation
1) CONFIGURE DIP-SWITCHES
Front Panel DIP-Switches
Front Panel DIP-Switch Location
SW1 - LOCAL DUAL LOOPBACK "LOOP"
When this DIP-switch is set to the "Loop" position, it sets the module to a dual loopback
mode on both the fiber and copper connections. By returning the DIP-switch to the
"Norm" position, the module resumes normal operation.
Local Module
BNC/UTP In
Fiber Out
BNC/UTP Out
Fiber In
Dual Loopback Mode
NMM2, GXTM2, GM3 or GM4. Management
Remote Module
Fiber In
BNC/UTP Out
BNC/UTP In
Fiber Out
Page 4
Advertisement
