Jabra GN9330e Quick Start Manual

How to connect with siemens openstage 30, 40, 60, 80

Hide thumbs Also See for GN9330e:

How to connect my Jabra GN9330e with Siemens OpenStage

30, 40, 60, 80

Jabra Link 14201-10

Prerequisite:

Jabra GN9330e + Jabra LINK 14201-10

In combination with one of the following phones:

OpenStage 30 / 40 / 60 / 80

Important:

Please note that Remote Call Control is only supported by the Jabra

GN9330e from version "L" or from date code 9/09.

1. Plug the 1-sided end of the DHSG cable marked blue into the socket

marked with a "headset" symbol on your phone.

2. Insert the RJ9 plug into the socket with the "phone" symbol and the

RJ45 plug into the socket on the Jabra GN9330e base marked with

"AUX".

1. Put the headset in the base and activate "DHSG" mode.

2. Hold down the "phone" button on the base of the Jabra GN9330e for

approx. 6 seconds until the online display (blue LED) on the headset

starts to flash. The current EHS is displayed to you by activating the

speaker controller in the form of the charge display (green LED).

https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c-

4140-9893-da33b8074349

11/05/2021 15:31

Page 1 of 3

Table of Contents

Do you have a question about the GN9330e and is the answer not in the manual?

Page 1 EHS setup: 1. Put the headset in the base and activate "DHSG" mode. 2. Hold down the "phone" button on the base of the Jabra GN9330e for approx. 6 seconds until the online display (blue LED) on the headset starts to flash. The current EHS is displayed to you by activating the speaker controller in the form of the charge display (green LED).
Page 2 Answer/end calls on the headset: Once the dial tone signal can be heard in the headset, you can answer the call by pressing the "Answer/end" button on the headset, while pressing it again will end the call. https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c- Page 2 of 3 4140-9893-da33b8074349...
Page 3 OpenStage 60/80: Menu> User> Audio> Settings> Headset> Cordless Important: The dial tone signal in the headset is transmitted only if the standard ring tones are used on your phone. There is no dial tone signal transfer for mp3 ring tones. https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c- Page 3 of 3 4140-9893-da33b8074349...