Operation With Tape; Playing A Tape - Aiwa HV-DH10 Operating Instructions Manual

Operation with Tape

z
TV/VIDEO
CLOCK/
COUNTER
i/SETUP
aPAUSE/
FRAMEF
r
Numeric
buttons
AUDIO
C.LOCK
CM SKIP

Playing a Tape

You will only be able to load and eject video cassettes
when the unit is plugged into an AC outlet.
This unit may also playback recordings from NTSC
tapes (on PAL TV).
Getting a better picture
When a cassette is inserted and playback started, the
automatic tracking function works to get the best
possible picture automatically. If the quality of the
recording is poor, repeatedly press CH/TRACKING
i+/k– on the remote control or CHANNEL +/– on
the front panel to manually adjust the tracking until
any distortions have been removed.
Note
Automtic tracking returns to the normal position when the
video cassette is ejected.
32
1
Make sure that you have correctly connected the
unit as described earlier in this book.
I/6 Turn on your TV.
Press I/6 to turn on the unit, then insert the
INPUT SELECT
video cassette into the unit.
REC. END
• The video cassette should have the window side
SERCH
OK/ENTER,
CH/TRACKING
2
Press C to start playing your tape.
i + /k–, j/l
sSTOP
• If you load a video cassette which has had its record
wREC
t
(SLOWT)
3
Press aPAUSE/FRAMEF to still a picture.
C
Press aPAUSE/FRAMEF repeatedly to
advance the tape frame by frame.
CLEAR
• Tapes can be paused for up to 5 minutes. After 5
• Still picture quality can be improved slightly by
SP/LP
4
Slow motion:
During still picture hold down t (SLOWT).
SHOWVIEW
The picture will be slowed down at about 1/19
times the normal playback.
• During slow motion, the noise bars may appear on
• If slow motion continues for more than 3 minutes, the
5
Press C to continue playing your tape.
Playback Search
During playback press t or r. The picture
is played back at 7 times normal speed. To return
to normal-speed playback, press C.
6
Press sSTOP to end playback.
Press z.
• If the end of the tape is reached, the unit will stop
Fast Forward/Rewind Search
From the STOP mode you can press t or r to
quickly move through the tape. If you wish to see a
portion of the tape during t or r press and hold
t or r. While the buttons are held down the
picture is played back at 7 times normal speed. When
you release the buttons t or r resumes.
facing up and the arrow facing away from you.
protection tab removed, playback of the cassette will
start automatically.
minutes the unit will stop the tape to prevent
damaging the tape or the unit.
pressing CH/TRACKING i+/k–.
the picture according to the status of tape. If
distortions can be seen in the picture, reduce them
with CH/TRACKING i+/k–.
unit will automatically change to normal playback.
playback automatically, rewind, stop, eject the tape.