Table of Contents
Advertisement
Chapter 2 - Installation
3. Put a split lock-washer and flat washer on a #10 (M4) or #12 (M5) screw and screw it into a top
mounting hole so it is secure, but not tight against the panel. Repeat for the other top mounting
hole.
4. Align the top mounting tab holes in the redundant power supply with the installed screws, slip the
tabs over the screws, and slide the power supply behind the washers, so it rests on the screws.
Tighten the screws.
5. Install screws and washers in the bottom mounting tabs and tighten.
- 12 -
Hide quick links:
Advertisement
Table of Contents
