Manufacturer Testing And Verification; Troubleshooting - Tiger SS11 Original Instruction Manual

9.

Manufacturer Testing and Verification

This product was manufactured under our single-unit control of quality and was passed with strict inspection in accordance
with our inspection standards.
Capacity (tonne) WLL (kg)
0.8 800
1.5 1500
3.0 3000
6.0 6000
Declaration of Conformity
Products are tested in line with the requirements within applicable sections of the European standard BS EN
13157:004+A1:2009, the Australian standard AS1418.2, the American standard ANSI/ASME B30.21-2005, and the South African
standard SANS 1636. Lever hoists supplied with slipping clutch overload protection are compliant with the Norwegian
Standard NORSOK R-002. All items comply with the essential health and safety requirements of the Machinery Directive
2006/42/EC. Tiger lever hoists are third party verified by SGS Certificate Number MDC 1302.
10.

Troubleshooting

Problem Cause
Chain is jammed Load is not being pulled in a straight line
Load swivel has ceased operating
Hoist is dirty, or hampered with foreign matter
Fall of chain is tangled
Hoist is overloaded
Brake mechanism has jammed
Hoist Seized Wear and tear
Poor maintenance and inspection
Poor storage and handling
Hoist is overloaded
Slippage of load Brake mechanism worn
Hoist is overloaded
Hoist not braking Brake mechanism worn
Load chain Damaged load chain, pinion shaft, gears or
catches or jams sheaves.
Load chain not installed properly (twisted,
kinked or "capsized").
Hook Latch does Latch broken.
not work.
Load hook bent or twisted.
Unit 1, Greensfield Industrial Estate,
Willowburn Avenue,
ALNWICK, NE66 2DG
Email: info@tigerlifting.com
Test Load (kg) Capacity (tonne)
1200
2250
4500
9000
Solution
Load chain to be positioned in a straight line
a)
b)
Refer to maintenance and repair section of this manual
Unravel and straighten chain
Check the load chain for elongation and replace as required.
Load hoist to recommended capacity only
Return to supplier or authorised service centre for repair
Replace hoist
Refer to manual for maintenance and inspection details
Always store unit in a dry and clean area
Load hoist to rated capacity only
Inspect brake (Chapter 5 Inspection). Replace brake discs or
repair brake as described in Chapter 7 Maintenance.
Load hoist to rated capacity only
Return to supplier for repair and testing
Disassemble hoist, inspect and repair or replace damaged
components.
Remove load chain and re-install.
Replace hook latch.
Inspect load hook as described in Chapter 5 Inspection.
Replace if necessary.
WLL (kg)
10 10000
15 15000
20 20000
Unload load and de-swivel
Replace hook assembly
www.tigerlifting.com
www.tigerlifting.com
Page 23 of 38
Manual Tiger SS11-PLH En 201704 v3.2
Test Load (kg)
15000
22500
25000