Mono setup example
How do I integrate the C6 SE into a single C6 column system?
1 Place the C6 SE at your desired
location and put the C6 subwoofer
on top of it.
2 Set the DSP mode of C6 SE
to PSSC IN.
(see "DSP MODE
TOGGLE" on p.12)
3 Use an XLR cable and connect
the TO C6 SE output socket on the
C6's mixer to the LINE IN socket at
the back panel of C6 SE.
4 Plug in the powerCON
the POWER IN socket on each units'
rear side panel and connect both
cables to the mains outlet.
5 Set up both column modules to
the corresponding connector on top
of C6.
6 Connect your audio source/s to
the mixer.
7 Turn the POWER SWITCH of C6
on first and C6 SE second.
The ON LED on each unit should
indicate a constant green light.
PROCESSED SUB
SLAVE CONTROL IN
cable into
®
GETTING STARTED
TO C6S E
XLR
LINE IN
100-240 V~ 50-60 Hz
Max. 2000 W
EN
powerCON
®
13