Table of Contents
Advertisement
MAKE SURE YOU DISCONECT ANY CHARGING EQUIPMENT BEFORE
INSTALATION:
car battery charger, notebook charger, etc.
Use Fig. 11 as a guide to take the following steps:
1) Connect the black Negative Power Supply wire (A) from the adapter to the ground
point.
2) Connect the red Positive Power Supply Wire (B) to the fuse number 301 in Fuse
Box and install the fuse (watch Fig. 12) supplied in the kit.
3) Connect Adapter 2 PINs CAN bus connector (C) to CAN Distributor.
4) Disconnect the Left headlight and Right headlight 2 PIN CAN bus connectors (F)
from the CAN Distributor. To do this you need to identify these two headlights CAN
bus connectors in the CAN Distributor (watch Fig. 14). It is really easy turn on the
ignition and remove one by one 2 PIN CAN bus connectors from the CAN Distributor,
when the headlight plug is removed corresponding headlight starts illuminate in
limp-home mode.
5) Connect Left headlight and Right headlight 2 PINs CAN bus connectors (F) to dual
connector (D) from the retrofit adapter, order does not matter.
Fig. 12 Fuse from supply kit
Fig. 14 CAN Distributor.
Revision–4. 19 March 2021
Installation
VERY IMPORTANT!
Fig. 15 CAN Distributor and Dual connector.
CARSYSTEMS.COM.UA
Fig. 13 Tail Lights 10 pin connector
11/16
Advertisement
Table of Contents
