•
Adjust the angle of the heater to approximately 45
angle from vertical.
•
You should regularly check the screws connection to ensure the heater is still
stable.
•
Plug in the power source and operate the controls. Check that all functions work
correctly and the installation is safe.
OPERATION
•
The appliance is switched on by means of a pull cord switch.
•
Pull the cord once: the heater will switch to low power setting (650W)
•
Pull the cord twice: the heater will switch to mid power setting (1300W)
•
Pull the cord three times: the heater will switch to high power setting (2000W)
•
Pull the cord for a fourth time: the heater will switch off.
•
The setting is indicated in a window in the lower section of the heater body.
NOTE: The heater is provided with an anti-tilt switch which will switch off the heater if it
is overturned, and will switch it on again automatically when it is restored to its upright
position.
O
which is the recommended
6
Heater Unit
Body
Locking Knob