IMPORTANT SAFETY INFORMATION Please read these instructions carefully before use and retain for future reference. • Check if the voltage indicated on the rating plate of the appliance corresponds to the local mains voltage before you connect the appliance. • Use this heater only as instructed in this manual.
WHAT’S INCLUDED • 1 heater unit • 1 user manual • 3 stand tube sections • Base • Cover plate • 3 Cable clamps • M5x30 screws 4 off • M5x6 screws 6 off PRODUCT OVERVIEW Heating Element Assembly Knob Body Position Indication Plate Pull Switch...
Page 4
INSTALLATION - STAND MOUNTING • Remove all package material and check the appliance, supply cord and the plug for signs of damage. • Insert the lower post assembly (11) into the base assembly (16) and then fix it tightly by means of 4 M6x30 screws. •...
Page 5
• Slide the second clamp (12) over top post lower section (9) then join onto the middle post and secure with 3 M5x6 screws. • Ensure the upper clamp is fitted to the thinner section of upper post. Clamp Lower Post Clamp Screws •...
• Adjust the angle of the heater to approximately 45 which is the recommended angle from vertical. • You should regularly check the screws connection to ensure the heater is still stable. • Plug in the power source and operate the controls. Check that all functions work correctly and the installation is safe.
• Do not allow any water to enter the appliance. • To store the heater, place it in a clean, dry environment, ensuring it is protected from dust. SPECIFICATIONS Model PEL01218 Rated Voltage 220-240VAC Frequency 50/60Hz Rated Power 2000W IP Rating...
Page 8
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL & ELECTRONIC EQUIPMENT When this product has reached the end of its life it must be treated as Waste Electrical & Electronics Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for the treatment, recovery and recycling of the materials used.