Advertisement
Install all components on the same local Ethernet subnet!
System Hardware
A rear panel allows a user to connect the QPU-L7 to a power source and to the network. Through the
network, the QPU-L7 has access to the LiDAR sensor and the Q
with the QPU-L7 is needed, the user may remote log in or attach accessories to front/rear ports.
DC Power In
External Fan Power
ATX Power On/Off
System Setup (Referenced documents are listed on the previous page in the Documents section.)
1.
Connect the QPU-L7 to the same local Ethernet subnet that the Q
sensors are on. The Ethernet (LAN) ports are at the rear of the QPU-L7.
2.
Connect the QPU-L7 to power at the rear of the QPU-L7.
3.
Press the power switch at the front of the QPU-L7 case so that the Power LED illuminates.
4.
From the Ubuntu® PXE Menu, select 0) Boot from local drive, then log in (username user, password letmein).
5.
Activate a license (see Q
execute
reboot
6.
Execute
ifconfig.
Q
DTC client, as explained in the Q
ORTEX
Contact: Quanergy Systems, Inc., 433 Lakeside Drive, Sunnyvale, CA 94085 | http://quanergy.com
• For purchases made directly from Quanergy: contact support@quanergy.com for any questions
• For purchases from a third party (value-added reseller/system integrator): contact them for support
© August 2020 Quanergy Systems, Inc., QPN 96-00031 Rev E
DVI-I Video
PS/2 Peripherals
DP1 Display Port
USB 2.0 (2)
Power LED
Temp, HDD, and Digial I/O LEDs
QPU-L7 Rear Panel (top), Front Panel (bottom)
DTC User Guide or Q
ORTEX
. The server daemon starts up and persists without additional user intervention.
Note the IP address listed as
ORTEX
LAN (2)
USB 3.0 (4)
Ethernet LEDs (2)
DTC Quick Start Card), open a terminal window, and
ORTEX
inet addr:x.x.x.x
DTC User Guide or Q
ORTEX
ORTEX
DTC client. When direct interaction
Serial (2)
Sound (2)
Remote Pwr Reset
Remote On/Off
Dual Mode DP, HDMI
USB 3.0 (2)
Drive Bay
DTC client and LiDAR
ORTEX
for future use with the
DTC Quick Card.
ISO 9001:2015 Certified
Advertisement
