Dometic TC14 Operating Manual page 12

Operation
Operating display
red (fig. 2 B, page 4)
blue (fig. 2 C, page 4)
6.4 Switch over between cooling and heating
➤ If you want to switch over between cooling and heating, press the button
"HOT/COLD" (fig. 2 D, page 4).
I
NOTE
The control unit of the cooling box has a memory function. It memorises
the selected temperature range for each mode (cooling and heating).
Thus the temperature range which is previously selected in the mode is
set again with each switching on or switching over.
✔ The red or blue operating display lights up and the device starts to cool/heat.
➤ When you want to finish the cooling or heating process, press the button
"ON/OFF" (fig. 2 A, page 4).
➤ When you stop using the cooler, disconnect it from the mains.
6.5 Select temperature
To avoid food waste, note the following:
• Keep temperature fluctuation as low as possible. Only open the cooling box as
often and for as long as necessary. Store the foodstuff in such a way that the air
can still circulate well.
• Adjust the temperature to the quantity and type of the foodstuff.
• Foodstuff can easily absorb or release odor or taste. Always store foodstuff
covered or in closed containers/bottles.
The status display of the temperature (fig. 2 F, page 4) indicates the selected
temperature range. With an increasing number of illuminating LEDs, the intensity of
the temperature range also increases.
I
NOTE
The following temperature indications are subject to tolerances and are
dependent on the measuring position.
12
Operating mode
heating
cooling
TC
EN