Transmitter Settings - H-Tronic HT8S plus Manual

– Batteries may not be short-circuited, disassembled or thrown into a fire. There is
a risk of explosion!
– Conventional non-rechargeable batteries may not be charged. There is a risk of
explosion! - Pay attention to the correct polarity when inserting the battery
(note plus / + and minus / - )

4. transmItter settIngs:

The device has six selectable modes of operation (factory setting 0) which are
programmed when the battery is put in. To change the default settings continue with
the following steps:
1.
Take the battery out the battery holder.
2.
Press any key for one second to discharge the buffer capacitor in the device and
erase previous settings.
3.
Select a mode: hold down the appropriate key (1-5) and insert the battery into
the device. If no key is pressed when inserting the battery factory settings (mode
0) will be installed.
4.
Release the button.
the FollowIng PreProgrammed modes are aVaIlable:
1. mode „0":
1.1
Operating frequency: 868.35 MHz
1.2
Transmission: Continuous operation. The transmission lasts as long as the
button is pressed.
2. mode „1":
2.1
Operating frequency: 869.05 MHz
2.2
Transmission: Continuous operation. The transmission lasts as long as the
button is pressed.
18 | Transmitter settings
Factory presets. The factory presets are installed when no key
is pressed in the battery is inserted into the device:
Mode that is installed when button "1" is pressed when inser-
ting the battery: