EnGenius DuraFon 4X Quick Reference page 3

c. Now choose 01-07 (group number) for the Extension number to be entered.
d. Now go back to Step a to select lines 2 through 4 and do the same. See the list below.
7) Group 1 = Line 1 = Programming # = 01. Blind programming = Menu 9,1,4, off, yes, 01 (then exit).
8) Group 2 = Line 2 = Programming # = 02. Blind programming = Menu 9,1,4, arrow up once, off, yes, 02
(then exit).
9) Group 3 = Line 3 = Programming # = 03. Blind programming = Menu 9,1,4, arrow up twice, off, yes, 03
(then exit).
10) Group 4 = Line 4 = Programming # = 04. Blind programming = Menu 9,1,4, arrow up 3 times, off, yes, 04
(then exit).
11) Note, out of the box no handsets are part of any groups. You must add groups to each and every handset
accordingly. No lines will be available until they are in one of these groups.
12) To add a group on a Handset, press 5, 2 then press ADD to add the group. Press 01 for group 1, and
ADD again if you wish to group it to 2 (02) and continue for lines 3, and 4 etc.
13) With Grouping you can remove or add lines (groups) to Handsets individually at any time.
Ref #8 – Adding a Handset to a group (for broadcasting):
1) On each handset, to add it to a group, or groups, PRESS MENU 5, 2, then ADD. A maximum of 7
groups can be configured. (01 through 07).
Ref #9 – Recovering the original Handset ID after having a phone repaired:
1) All phones sent in must be registered to our test base. This causes it lose the registration to your base.
Unless you deregistered the Handset ahead of time, the Base Station unit still thinks that ID is still in use.
For example if you have 4 Handsets, with ID 10, 11, 12, and 13 and you send Handset 12 for repair.
When you re-register it, you will get ID 14 because it still thinks 12 is in use.
2) To get ID 12 back, you must erase the Base Station information for Handset 12, which then frees it up for
you to then use.
3) To erase a registration ID that is stored by the Base Station unit, get an administrative handset (ID 10 or
11) and press Menu 9, 2, then 1 to choose which handset registration ID to clear. In our example it would
be extension ID 12.
4) Now ID12 is clear and available as the next registration ID. The Base Station unit gives IDs to Handsets
in numerical order of free IDs. You can now go to #3 and go through the normal Handset registration
process.
Still having trouble? Call EnGenius technical support at 888-735-7888 x 514 or email
For further support please email support@engeniustech.com Revised 01/17/2012