Ness 100-187 Installation Notes

Ness 100-187 Installation Notes

Scr single channel receiver

Advertisement

Quick Links

I N S T A L L A T I O N N O T E S
NESS SCR SINGLE CHANNEL RECEIVER
NESS SECURITY PRODUCTS
Australian Communications Authority
RADIO COMMUNICATIONS COMPLIANCE
PART NUMBER: 100-187
MODEL: SCR Single Channel Receiver

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 100-187 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ness 100-187

  • Page 1 I N S T A L L A T I O N N O T E S NESS SCR SINGLE CHANNEL RECEIVER PART NUMBER: 100-187 MODEL: SCR Single Channel Receiver NESS SECURITY PRODUCTS Australian Communications Authority RADIO COMMUNICATIONS COMPLIANCE...
  • Page 2 INTRODUCTION PROGRAMMING The Ness Standalone Wireless Receiver is a The Ness Standalone Receiver can be unique high performance 303.875Mhz radio programmed with up to four similar Ness receiver designed to operate in conjunction with transmitting devices i.e. either Radio Key devices...
  • Page 3 Radio Key. Programming Steps above. Pressing the "ON" button on a Ness Radio Key 1. Place the Program Link onto the number of the will turn the Relay on. Further presses of the "ON"...
  • Page 4 Application 4. Control Panel Arming using an OPTIONS - MOMENTARY Armed/Disarmed output from the Panel. Use this application for correctly Arming and Link set to Momentary ( Can be used with Radio Disarming a Control Panel using the ON and Keys or Alarm Devices) OFF buttons on a Radio Key as long as there Application 1.
  • Page 5 Note - The Standalone receiver provides no Sales Branch. means of identifying which Key or Device has caused the Low Battery alarm however all Ness Keys and Alarm Devices display Low Battery by fl ashing their LED instead of turning it on steady...
  • Page 6 WIRING SCR TO L8 PANEL 100-187 NESS SCR RECEIVER TAMP +12V NESS L8 MAIN BOARD INPUT +12V PANIC TAMP BATT WIRING SCR TO PRO-LD PANEL NESS PRO-LD MAIN BOARD AREA 1 AREA 2 Al 1 Al 2 Tamp Excl Batt...
  • Page 7 WIRING SCR TO PRO-LX PANEL 100-187 NESS SCR RECEIVER NESS PRO-LX MAIN BOARD...
  • Page 8 NESS SECURITY PRODUCTS Australian Communications Authority RADIO COMMUNICATIONS COMPLIANCE NESS SCR RECEIVER INSTALLATION NOTES Document part number: 890-129 For products: 100-187 Ness SCR Receiver © 2003 Ness Security Products Pty Ltd ABN 28 069 984 372 Specifi cations may change without notice.

Table of Contents