Setting A Temperature - Mangrove Jack's DUAL TEMPERATURE CONTROLLER Instructions Manual

Button Press Once
Power Switch controller on and off.
Set Select, or finish step.
Up Display target temperature.
Down Display the hysteresis value.
The temperature displayed on the screen under normal working
status shows the current temperature.

Setting a Temperature

1. Press the Set button and hold for 3 seconds. The Set indicator light
on the screen will appear.
2. Press Set button again. The temperature displayed on the screen
now is the target temperature.
3. While holding in the Set button, use the Up or Down buttons to enter
a desired target temperature.
4. Once you reach your desired target temperature, press the Power
button to set that temperature. You will then return back to the main
screen.
MANGROVE JACK'S DUAL TEMPERATURE CONTROLLER
Hold for 3 Seconds
Indicator light will appear.
Holding Continuously
Hold the Set button and
pressing either the up or down
to enter target temperature.