Advertisement
INSTALLATION PROCEDURE
VENTILATION
Although your new Receiver rarely develops high heat, it is still recommend
ed that you leave the back of the cabinet open. If this is not possible, provide
several large holes or slots as low down and as high up in the cabinet back
as possible. As an alternative, holes may be provided in the sides, bottom or
top of the cabinet. Remember that really effective ventilation requires provision
for cool air to enter at the bottom and hot air to leave at the top. A minimum
clearance of two (2) inches should be allowed on each side and in the rear,
between the chassis and the cabinet, and three (3) inches are required above it.
Isolate any accessories which might interfere with ventilation. For example,
do not drape plastic or rubber covered interconnecting cable over the equip
ment.
POWER REQUIREMENTS
Connect the AC line cord to any outlet furnishing 117 volts, 50/Ó0 cycle
AC current. The voltage may vary between 105 and 1 2 5 volts. Two auxiliary AC
power outlets are provided on the rear panel of your receiver, one being alive
at all times and the other being live only when the power switch is ON. Any
accessory equipment (tape recorder, phonograph record player, etc.) may be
connected to these receptacles and if connected to the SWITCHED receptacle,
this equipment will be controlled by the ON/OFF POWER switch.
FUSING
A fuse is a safety device used to protect the receiver against possible
damage due to overload, short circuits, and excess current. This receiver em
ploys three fuses for protection. The AC fuse, labeled 3À-3AG is used to pro
tect the entire system. The other two speaker fuses, also 3A-3AG, are used to
prevent damage to the output stage of your receiver.
The output of your receiver has been designed to operate with a MAXI
MUM of 3 amperes of current in each channel. Under certain conditions, it is
possible to draw more than 3 amperes through the output stage which would. In
turn, blow the speaker fuses. This could be caused by using multiple speaker
systems where the total impedance falls below 4 ohms. Whenever you plan to
operate more than two speakers simultaneously, make absolutely sure that their
total load impedance WILL NOT fall below 4 ohms.
In the event of fuse failure, replace ONLY with the same fuse type used.
NEVER replace with a fuse of a higher rating. To do so will NOT protect
your receiver and could result in severe damage to it which will not be covered
under the warranty policy.
SPEAKER PHASING
When more than one speaker is used in a music reproducing system, the
speakers must be connected in a manner which will allow them to work together.
Both left and right speakers must operate in perfect unison, moving back and
forth together. If the speakers are moving in opposite directions, the result will
be diminished bass response and decreased realism of sound. When this occurs,
the speakers are said to be out of phase. Checking for proper phase and cor
recting, if required, is quite simple.
1. After connecting your speakers, place the stereo receiver in the L & R
or monophonic mode of operation,
2. Play a record, tape, or FM broadcast which has a single speaking or
singing voice, or a solo instrument.
3. The voice or instrument should appear to be coming from an area
directly between the two speakers. If the speakers are out of phase, the sound
will appear to be coming from the two individual speakers.
4. If you determine that the speakers are out of phase, simply disconnect
the leads from only one of the speakers and reverse them. The system will then
be in phase.
This completes your speaker connections. Your receiver is a solid state
device which does not contain audio output transformers. It is therefore not
necessary to match the impedance of your speakers to the receiver. Your unit
will perform perfectly with any speaker which has an impedance of 4 , 8 or
16 ohms.
Advertisement
