Troubleshooting - AgfaPhoto Optima 8328m User Manual

AgfaPhoto OPTIMA 8328m

Troubleshooting

Problem
Power does not turn on.
The camera does not take
pictures.
Image is not recorded when
the shutter button is pressed.
The flash does not fire.
Image is blurry or out of focus.
Image is not displayed on the
LCD monitor.
Recorded images are not
saved in memory.
Cannot transfer images to a
computer after connecting the
USB cable.
Card error
Cause
Battery is inserted in the wrong
direction.
Batteries are dead.
The battery compartment door
is open.
The flash is charging.
Memory is full.
Memory card is not formatted
correctly.
The Flash is charging.
Memory is full.
Flash is set to OFF.
The camera was moving when
the image was captured.
The subject was beyond the
range within which the camera
can focus.
A memory card with non-DCIF
images (recorded with other
camera) is loaded.
The camera was turned off /
powered down before the
image was stored in memory.
USB driver is not installed.
The memory card format may
not be correct.
55
Solution
Reload battery in the correct
direction.
Replace or recharge batteries.
Make sure the battery
compartment door is securely
closed.
Wait for the flash to charge.
Insert a new memory card.
The card may be defective,
use a new card.
Wait for the flash to charge.
Insert a new memory card.
Set the flash to any mode
except off.
Hold the camera steady when
shooting pictures.
Turn the Macro mode on it the
subject is within 15 cm or 40
cm.
Do not use Macro mode when
shooting distant subjects.
This camera cannot display
non-DCIF images.
If the battery low indicator
appears on the LCD monitor,
replace the battery
immediately.
Install the USB driver before
you connect the camera to a
computer / turn the camera on.
Re-format the memory card to
the FAT format using a card
reader in Windows.