Table of Contents
Advertisement
AgfaPhoto Compact 104
Appendix
About Folder and File Names
Your camera automatically creates specific directory of folder in the internal memory cards to
organize captured images, videos and audio files.
File Naming
File names begin with "DSCI" and followed by a 4-digit number that increases in sequence. File
numbering starts from 0001 when a new folder is created.
If the highest folder number is 999 and the highest file number exceeds 9999, the camera will
display the warning message "Folder cannot be created". When this happens, try one of the
following ways:
• Reset the file number. See "Setting File Numbering" on page 52
• Plug in a new memory card.
Do not change the folder and file names in the memory card using your PC. It may be
unable to playback the data using the camera.
Troubleshooting
Problem
Camera does not turn on.
Camera turns off
automatically.
LCD turns blank.
Empty battery icon is
displayed on the LCD,
then the camera turns
off.
LCD monitor displays
' No image' .
LCD monitor displays
' Not available for this
file' .
LCD monitor displays
' Memory full' .
LCD monitor displays
' File locked'
LCD monitor displays
' Format error' .
LCD monitor displays
' Card locked' .
LCD monitor displays
' Copy error' .
No image displays on the
TV screen.
The lens got stuck up.
Cause and/or Action
The batteries may be exhausted. Charge or replace the batteries.
Press Power button and Playback button to turn on the camera.
Press any button except the Power button to turn on the LCD.
Batteries are exhausted, please replace or recharge.
There is no image file in the memory card. Image file format may not
be supported.
Function is only available for specific file types. File format is not
supported.
Memory card is full. Replace the memory card with a new one or
delete unnecessary images.
This file is locked. Unlock the file. See "Protect" on page 45.
The card may be damaged. You can either change the card or wipe
to clean the connected points.
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
The memory card is protected. Remove the card and slide the
write-protect switch to its unlock position.
The memory card is full. Replace card or delete unnecessary files.
Incorrect TV-out type was selected. Set the correct TV-out type to
match your TV system.
Do not force the lens to go back.
The type of the battery used may be incorrect or the battery power
level is too low. Change the battery or charge the battery before
using the camera.
57
Advertisement
Table of Contents
