Table of Contents
Advertisement
produced by the photocell through the control circuit into built-in
accumulator, also can directly charge the mobile telephone with the
electrical energy produced by the photocell, on condition that have not
illumination, may charge the built-in accumulator through alternating
current or rear non-crystalline board, also can charge the electrical
appliance with stored electrical energy via the output plug by the control
circuit .
Ⅳ. Using method
1.
pull the protective film of cell board apart and wipe it
clean , switch to OFF position, place charger suffering
the direct radiation under the sunlight, will brighten red
indicating light. In order to fully make use of solar
energy, it is best to be vertical with the light, generally
shine above 8 hours under the abundant sunlight, built-in
accumulator can be fully charged.
2.
When no sunlight for a long time, can make use of
configured AC to DC charger to charge the built-in
accumulator, charging method is connect configured AC
to DC charger to DC input interface through connecting
Advertisement
Table of Contents
